We size every Florence, KY system to basin capacity and inflow rate, not a generic package.

Not every Florence, KY basement needs full-perimeter drain tile — sometimes a targeted section addressing the actual entry point is the more cost-effective, equally durable fix. We size the scope to what the inspection actually shows.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Most Florence, KY inspection requests get a response within a day or two.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.

Every Florence, KY Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Florence, KY basement layouts.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.

Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.

"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Florence Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Florence Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Florence Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Florence Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Florence, KY area's typical rainfall intensity.
If disruption is a major concern, we can discuss the baseboard channel alternative instead.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
We install and repair interior drainage systems throughout Florence and the surrounding Florence, KY service area, including the zip codes listed below.



Zip codes we serve in Florence, KY: 41042 41022
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.